Twisted Pear Audio Opus
The second of our picks comes from Twisted Pear Audio's Opus DAC. Twisted Pear Audio is the collaborative effort of Russ White and Brian Donegan, who are both capable engineers and audio enthusiasts. The benefit of this teaming is that we find a number of kits ranging from volume control, selection controllers, DACs, voltage regulators, and even amplifier modules based upon some of the latest technology and at prices that blow the world of high-end audio wide open.
The Opus is based on Wolfson's WM8741, a differential voltage output DAC that supports up to 24-bit 192KHz resolution (source permitting). Dedicated output stages and power supply kits are available from Twisted Pear, designed from the ground up to compliment the Opus DAC. For those of you wishing to drive into single ended inputs on your preamps or amplifiers, the Ballsie converter/buffer module is the way to go. Total price including the Ballsie modules will range from $200~$350, on par with the price range of Doede's kits mentioned earlier. The Opus is available in a variety of configurations, from a bare PCB to a fully soldered and ready to go kit. There are no components to solder in any of the full kit format options, apart from the input/output terminal blocks depending upon individual configuration requirements.
USB to I2S input modules are also available, although Twisted Pear's design powers the PCM2707 from the USB bus. An asynchronous clock module is available that allows the I2S stream to be re-clocked, thus lowering jitter to aid high fidelity audio reproduction. Another option, rather than using the USB to I2S converter, is to opt for the MUX receiver module. Up to four S/PDIF inputs can be connected while a control switch allows you to select the preferred input. The MUX module is capable of outputting 24-bit PCM in I2S format for those who wish to playback recordings of this resolution.
I decided to use the Doede USB converter and go with a dual differential Opus DAC configuration requiring two PCBs both switched to mono mode supporting stereo left and right respectively. In my case, audio output feeds into a 3A5 dual triode per channel, followed by a Sowter 8650a balanced to a single ended 9:1 ratio output transformer. This is probably not a setup that will appeal to those immersed in the merits of signal to noise ratios and accurate square waves, but it's a solution that sounds very appealing to my less than golden ears.
Facebook
Twitter
RSS
114 Comments
View All Comments
Clauzii - Monday, December 1, 2008 - link
.. I can recommend a Terratec Phase 22. No computernoise whatsoever. Pure, clean sound. I don't have a surroundsetup, but movies through this card sound brilliant, with a lot of detail and no digital 'fnitter-fnatter'.Clauzii - Monday, December 1, 2008 - link
Have to correct myself: With the card You can actually hear all the bad mixing of the movies themselves.daar - Monday, December 1, 2008 - link
Honestly, for a tech review site, I'm very disappointed that you nixed any pro sound cards and went for the audiophile kool-aid. Proper regulation and filtering can deliver clean enough juice for the best audio applications and while the USB option is kind of interesting, it creates more clutter, is more expensive, and the supposed better quality can't even be objectively tested.There wasn't even an attempt to build a measurement procedure, and while some sustain the notion that audio is beyond measurement, since when does AT throw out standard science and efficient engineering in favor of pseudoscience?
RobinBee - Monday, December 1, 2008 - link
"Proper regulation and filtering"Yes. A good motherboard does this. And: A hi-fi sound card such as ASUS Xonar D2 (PCI bus) delivers »clean juice«, very much better than Creative's x-fi. And: A good case makes a pc rather quiet.
RagingDragon - Saturday, December 6, 2008 - link
And a sufficiently powerful amp and/or headphones with good isolation make PC noise irrelevant.Servant of Shodan - Monday, December 1, 2008 - link
Not meaning any disrespect to the author - it was a good article - but I've notice a lot of camera reviews recently, and now a review about audiophile stuff... and it just seems so out of place for a PC enthusiast site.There are hundreds of credible sites for both cameras and stereos/speakers/amps/etc.; and I feel that it sort of muddies the waters here to have these types of articles, when there are other excellent places where they fit in perfectly.
I come to Anandtech for computers. I think it should keep to that topic.
SpeedyVV - Monday, December 1, 2008 - link
Holy cow, audiophiles i think are THX certifiable!!!Can you guys actually hear yourselves???
All joking aside, I love music, and sound, and guitar tube amps, a nice hi-fi.
But the stuff you guys talk about is way, WAY, beyond me ;-)
Boushh - Monday, December 1, 2008 - link
DRC does realy work. Last year I exchanged my old SONY AV receiver for a new Denon AVR-3808 with Audyssey. With the SONY I was unable to get a good sound at my listning postion (specialy the rears never actually worked). And even though I had my reservations for things like Audyssey, I ran it on the Denon. And low and behold: Now I was in the middle of everything. I was realy amazed that taking some samples with a microphone could have such impressive results.The second thing: DAC's for computers. I recently saw that Cambridge Audio released a DAC for (among other things) computers (http://www.cambridgeaudio.com/summary.php?PID=320&...">http://www.cambridgeaudio.com/summary.php?PID=320&.... Maybe a good idea to compare that to the setup used in the article. It seems to me that instead of all those components it would (for the most of us) be alot easier if it was just in one box. But maybe that is just me :-)
Anyway, nice article. It shows that people who are intrested in audio and are willing to do something for it are always on a never ending road B-)
strikeback03 - Monday, December 1, 2008 - link
... that this article shows that looks are not everything, as those drivers look like the cheap junk that comes in stock car systems.jabber - Monday, December 1, 2008 - link
They probably are! Remember in the world of 'high-end hi-fi' you build a component out of $20 worth of bits, stick a bit of varnish sanded wood on it then add on the 2000% 'hi-fi mug tax'.Its one of the best businesses to be in if you are unprincipled and lazy.
Your customers are easy because they have invested so much money in their systems they are always open to fear and doubt about it. Easy prey!