Enermax Pro82+ 385W


When we tested the Modu82+ and Pro82+ in the middle of this year, we were very satisfied with the performance both series delivered and awarded both our Gold Editors' Choice Award. We included the Pro82+ 385W version in this roundup to see how it matches up to other models in this category. The power supply comes in a gunmetal finish with a golden fan grille as expected.


The inside is similar to the Liberty series. It also comes with similar components, which might have been the reason why Enermax upgraded the Liberty in the first place, putting the new good ideas from the Pro82+ series into the old Liberty line. Another difference are the Chemi-Con capacitors in the secondary part, which the Liberty Eco doesn't have.

The Pro82+ comes with only one 6-pin PEG connector, since Enermax didn't see the need for more in a 385W power supply even though the 400W Liberty comes with two. We have again three cable harnesses but this time strictly separated into Molex or SATA like the competition. There are four SATA connectors on one cable harness and two cable harnesses with three Molex connectors each.

Enermax Liberty Eco 400W - Performance Enermax Pro82+ 385W - Performance
Comments Locked

39 Comments

View All Comments

  • Martin84a - Monday, January 5, 2009 - link

    I think it says the german and the english site, run things pretty seperately.

    250watt, 16a on the 12v rail that results in a ~300mV ripple. That's a lot. We are not even talking 80% or 100% of its max rated capacity.

    I know that are "allowed" to vary 10% on the 12V rail, but i still think it is a testament to the quality of the PSU. Look at the competetion next to it, nearly straight line.

    I recently had an Antec Truepower 480 watt dying on me. I had it for a little more than 3-4 years. Prior to buying it i did a tons of research. Anandtech also gave it a very good score. Today it is clear that a lot of these has failed, because of some very shitty caps being used. You don't see this in most of the reviews, because they only test if for a day or a week or so. Warranty is a big deal for a lot of people, including myself. I won't buy western digital or maxtor anymore, because i have had too many dying on me, granted they have been running for 3-4 years. Seagate give a 5 year warranty as the only HDD manufactor, so of course i pick them.
    The same with PSU's, I still consider the Seasonic S12II a good PSU, but i would rather pick a PSU with a better warranty.
  • kenyee - Friday, January 2, 2009 - link

    They just don't make them as well as they used to. I bought one of the expensive ones a year ago because it was the quietest around at the time...croaked after a month. Didn't bother sending it back under warranty because I didn't think it was worth it. It also doesn't support older 2.0 systems which I did send it back to them for but they could have told me via email :-P
  • Finraziel - Thursday, January 1, 2009 - link

    Although I understand what you're saying about the 10% load and how no PSU comes close to 80% efficiency there, would it be possible to still post the actual results of the different psus rather than only the rather blunt comparison in the graph? Many systems may not go far below 20% load with these psus, but if you're intent on setting up a very efficient pc it's not that hard to approach or even duck onder 30 watt idle. So in those cases, even though it's not close to 80, it'd still make a big difference wether the efficiency is 50, 60 or 70%...
  • Christoph Katzer - Thursday, January 1, 2009 - link

    Did a small update to the efficiency page. Thanks for the suggestion.
  • sonci - Thursday, January 1, 2009 - link

    So, best PSU regarding efficiency should be ENERMAX Liberty ECO, cause for 24/7 use, you hardly need 50% load..?
  • Christoph Katzer - Thursday, January 1, 2009 - link

    Depends on your system power requirements. There is a difference if you just need 50 watts or 150. Check the power consumption first, then check in which state you are running most of the time and then check which PSU would fit best. From some of the tested units we have separated reviews already where you can check the exact efficiency at a specific load.
  • JonnyDough - Wednesday, December 31, 2008 - link

    You really DO listen to your readers! KUDOS. You're one of the few companies that does.
  • sonci - Wednesday, December 31, 2008 - link

    AnandTech
    Thankyou for your honest work..
    Happy new year!!
  • JeBarr - Wednesday, December 31, 2008 - link

    I can vouch for the S12II 330W and it's ability to run an hd 4850. Originally I had installed the FSP group ZEN 400W fanless, but due to orientation of PSU inside of htpc case did not allow the heatsink to function as designed, so I gave the seasonic a try and have no regrets. It also helps that the rest of my components are low-power, of course.
  • marc1000 - Wednesday, December 31, 2008 - link

    why does akasa products never show on Anandtech?? well, I have one Akasa AK-P300PG (or something like that), it's a 300W unit. I used to power a Pentium-D 945 with a radeon 3850 (now i have a C2D e7200) and it works just fine. silent and stable power. It's a great product that could be included in future reviews.

    by the way: HAPPY NEW YEAR!!! :D

Log in

Don't have an account? Sign up now