SATA II to the Power of 3.0Gb/sec: Three Drives Reviewed
by Purav Sanghani on June 25, 2005 7:06 PM EST- Posted in
- Storage
Thermal and Acoustics
Heat and sound are also two very important factors in drive performance especially when considering where they will be used. A loud hard drive which becomes warm very quickly may not be the best choice for home theater PCs or any PC without adequate cooling and the noise alone could be a bit annoying. Take a look at how each drive performed as far as heat and noise output goes.
Thermal
Temperature readings are taken directly off of the hard disk drives topside above the platters.
The overall idle temperatures of each drive are not extremely high lingering at about 41-42 degrees celsius. But...
...when comparing them to each drive's operating temperatures, they come close to being the warmest running drives on the list at 47-48 degrees, at the same heat level as the 10,000RPM Raptor and 16MB DiamondMax 10..
Acoustics
To measure the sound output of each drive we have taken decibel readings of each drive at their startup phase as well as the sound output while there is disk activity.
Sound output is never an issue if a high quality sealed case is used to house the PC's components but it can get annoying with a few hard disks churning away. Each of the SATA300 drives produced a reasonable amount of noise, not really as quiet as the SATA150 SpinPoint series, but nowhere as loud as Maxtor's DiamondMax 10.
Facebook
Twitter
RSS
52 Comments
View All Comments
Justin Case - Saturday, March 18, 2006 - link
Does anyone really believe Seagate 7200.8 drives can sustain 70 MB/s in the inner sectors? I have three of those and they struggle to reach 38 MB/s. Anyone with a clue about hard drives would have spotted a screw-up in the benchmarks (and this isn't the only one). Here is the full WinBench99 graph for a Seagate 7200.8:http://www.storagereview.com/articles/200504/20050...">http://www.storagereview.com/articles/200504/20050...
Anandtech is even less credible than Tom's Hardware, these days. What a joke. I hope Anand got a big fat check from Seagate for publishing this "review"...
PuravSanghani - Tuesday, June 28, 2005 - link
#24 & 25: Our apologies for such a delayed reply. The reason we used the older v6.39 driver is that it is the latest driver Giga-Byte has released on its website.Though Nvidia may have implemented newer features in the v6.54 release, the driver package the motherboard manufacturer has on their website is usually tested for their particular boards.
We will definitely look into the newer versions in the future to see if they provide any useful updates that apply to our review topic and use them accordingly.
PuravSanghani - Tuesday, June 28, 2005 - link
#44: By "% Difference" we mean the difference between the time it takes to zip the file as a task by itself and the time it takes to zip a file while Outlook is importing 400MB of emails into its Inbox.#45: They are there.
#48: The transfer rates are actually measured in MBytes/sec. But yes, the results are correct and the benchmarks have been run twice to confirm these numbers. Also, many of our readers have pointed out that the 3.0Gbp/sec transfer rates, or transfer rates higher than those we have encountered, are mainly achieved when the drives are setup in RAID arrays.
#49: Actually, our results are of the drive itself in a silent room with no PC fan or other hardware running. We turn off all other system fans and take sound readings 1" away from the side of each drive during its startup phase as well as during normal operation, specifically during Windows startup.
We will be sure to specify this in future reviews.
Sorry for the bulky reply, but I hope it helps.
Purav
yacoub - Tuesday, June 28, 2005 - link
#45 - Well, Anandtech's noise measurement is clearly pretty pointless if they all come out so close together. That generally means they aren't testing the drive itself for its noise output, but then entire case with whatever other noisy components are in there. Guess we'll have to wait for SilentPCReview to test the new drives to find out how quiet they are for those who -aren't- running 50decibel systems. =Ptinyabs - Tuesday, June 28, 2005 - link
Why does new drives have 60-70Mb of Begin transfer rate? Is that correct?BornStar18 - Tuesday, June 28, 2005 - link
LX-Did you miss page 13?
Zak - Monday, June 27, 2005 - link
Why using megabits per second in hard disk review if most people are used to megabytes? It's a bit confusing.-Z
LX - Monday, June 27, 2005 - link
Incomplete review.What about noise?
What about temperature?
ElFenix - Monday, June 27, 2005 - link
on page 12, is it just how i'm reading these or does it indicate that the % done is much better under multitasked than when only running the zip?yacoub - Monday, June 27, 2005 - link
Wow, that review left me somewhat uncertain.While reading it I started out liking the Hitachi best, but then around a third of the way through it started to suck, but then again near the end it looked good.
The Raptor still looked like the champ for the first third of the review, but then the 400GB Barracuda shined for a few tests (probably the important ones, surprisingly) such as Sustained Transfer Rate (where it blew away everything else though the 300GB DiamondMax 16MB came close) and Real World File System Tasks with the 300 1MB files, etc.
When it comes to thermals they all suck except for the DiamondMax drives, imho, and as far as acoustics go, forget it (get a drive suspension rig and isolation enclosure or get laptop HDs if you're really picky about noise).